Pressure washer hoses are durable and long-lasting, but you may experience leakages over time because of careless use. Repairing the washer hose is a cost-saving decision over replacing it with a new one. But can a pressure washer hose be repaired?
Yes, you can repair it. Switch off the pressure washer, remove water, and locate the leakage. Once found, cut with a sharp knife, install couplings and connect them together.
You will get step-by-step guidance in this article to learn how to repair the pressure washer hose properly.
Step-by-Step Guide on How to Repair a Pressure Washer Hose?
Step 1- Switch off the pressure washer.
First of all, switch off the pressure washer. Not only to turn off the button but also to unplug the pressure washer from an electric source.
Step 2- Remove Water
Before repairing, ensure all the water is removed from the hose. Otherwise, your experience will not be good if you have a wet hose.
Step 3- Identify the leak or damage.
Now thoroughly check the pressure washer hose, identify the leakage, and mark it for repair.
Step 4- Cut the hose.
With a sharp knife, make a square-shaped cut around the leaking area on the hose. Ensure the cut should be smooth.
Step 5- Use Couplings
Now, insert the male coupling from one side of the hose. Then insert the female coupling on the other side of the hose. To keep coupling at their place, you should use compression rings.
Once you have inserted the couplings on both sides, now connect them together. Use a wrench for a tight connection. Once repaired, test it by running the water.
Final Verdict
Pressure washer hoses are costly; repairing can be a desired choice if you have leakage in your hose. You can extend your pressure washer hose and save money by repairing it.
